Goodbye little buddy! But here was the thing, it is the only light in the room. Do you see the problem? To take it down I had to turn off the power but with no power I had no light to take it down. Ahhh things are never simple.
And speaking of never simple, I was home alone doing this project. The hubs is in 80 degree Miami and I am stuck in feet of new snow schools closed lovely Madison. I ran downstairs into the very depths of our basement to shut off the power but of course the circuits where not labeled correctly and the one named "hall bath" did not turn off the power to the hall bath. Usually no prob...one person stands in the bathroom, one goes downstairs and turns things on and off until the other yells "that one"! But nope, I had to switch off one circuit, run upstairs and around the corner to see if the light was still on, run back downstairs and try another one. I ran up and down the stairs 11 times (yes, I counted) before finding the right circuit. U-G-H!
OK, but back on track. So finally I turned off the power and then I had to search around the house for light. After a few laps I headed into the garage and grabbed these babies.
Wondering what's up with the dark pictures? Well, see the thing is when a room is dark, the pictures are dark. Sorry!
So in the romantic light of the camping lantern I took down the gold monster. Goodbye. Goodbye. Luckily no huge problems taking it down. The screws came off. I did remember to remove the light bulbs first, just in case it came crashing to the ground. And I even saved all the pieces so I can pass this baby on to the Habitat ReStore (which is also where the mirror is going).
But of course a boomerang project developed. You know, a project that happens when you start one project and then another project comes up that has to be done to complete the first project...a boomerang project. In this case the boomerang project came because of these
Huge screws where holding the fixture to the wall and huge holes where for some reason needed for those screws. No idea why. I had never fixed a hole in the wall before. But hey, no time like the present to learn so I went to eHow and found this tutorial on how to patch a hole in drywall. And happily I already had all the supplies I needed except the self-adhesive mesh tape. But all that took was a quick trip to my local ACE.
As instructed, I cut a piece of mesh tape and adhered it to the wall. I put the spackle over it and let it dry. The next morning I lightly sanded it and used spray texture to match the rest of the room. Damn, I am good!
I know, great picture huh?!?! But you don't see two holes on either side of the wires anymore, do you?
So the wall is ready for the new light. And I will let you in on a little secret...I just put the light up and I love it! But I'm not quiet ready to show it to you yet. However, I will say I still have all 10 fingers and my hair is not standing up on end. An electrical success (and my first electrical project, may I add). So go ahead, pat me on the back and say good job :)
yay! can't wait to see the finished bathroom. You want to see dated lighting fixtures, I need to send you a pic of our hallway fixture. I'm pretty sure it is older than our house (1960)!
ReplyDelete